Start Automatic Ventilation Operations
6 - 20 Operator’s Manual of Anesthesia System
WARNING: Airway pressure and ventilation parameters related to respiration, such
as flow rate, minute ventilation, apnea, are not monitored during
HFNC.
WARNING: An SpO
2
monitoring device should be used to monitor SpO
2
during HFNC.
WARNING: Low gas supply pressure may cause inaccurate O
2
concentration control.
WARNING: Do not use antistatic or conductive breathing tubes. Using tubes made
from such materials will expose the patient to electric shocks and may
cause fires in an oxygen-enriched environment.
WARNING: The equipment must be used under the supervision of professional
medical personnel. If a fault occurs to the equipment or the patient fails
to perform enough spontaneous respiration, professional medical
personnel can give immediate help.
NOTE: Stop the automatic ventilation before starting the HFNC. Otherwise it
may cause inaccurate accuracy of the automatic ventilation or limited
flow adjustment of HFNC.
NOTE: HFNC can be started only when the oxygen supply is connected.
To start the HFNC:
1. Connect the HFNC tube, See "High-flow Nasal Cannula Oxygen (HFNC) Tube" on Pages 3-7.
2. Press the HFNC switch to start the HFNC.
3. Adjust the oxygen concentration and total flow.
4. Press the HFNC switch to close the HFNC after use.
Figure 6-17 HFNC Screen
6.8 Start Automatic Ventilation
NOTE: Before starting a new automatic ventilation mode, ensure that all
related ventilation parameters are set appropriately.
NOTE: Close the HFNC before starting the automatic ventilation to avoid
affecting the accuracy of the automatic ventilation.
To Next Page
Loading...
Need help?
General
