225
Setting from the parameter unit, operation panel
4
PARAMETERS
(2) Disable the setting dial and key operation of the operation panel (Press [MODE] long (2s))
â‹… Operation using the setting dial and key of the operation panel can be made invalid to prevent parameter change
and unexpected start and stop.
â‹… Set "10 or 11" in Pr. 161, then press for 2s to make the setting dial and key operation invalid.
â‹… When the setting dial and key operation is made invalid, appears on the operation panel. When the
setting dial and key operation is invalid, appears if the setting dial or key operation is performed. (When
the setting dial or key operation is not performed for 2s, the monitor display appears.)
â‹… To make the setting dial and key operation valid again, press for 2s.
4.22.3 Buzzer control (Pr. 990)
The above parameters can be set when Pr. 160 User group read selection = "0". (Refer to page 156.)
The above parameters allow its setting to be changed during operation in any operation mode even if "0" (initial value) is set in Pr. 77 Parameter write
selection.
4.22.4 PU contrast adjustment (Pr. 991)
The above parameters are displayed as simple mode parameters only when the parameter unit (FR-PU04/FR-PU07) is connected.
When the operation panel is connected, they can be set only when Pr. 160 User group read selection = "0". (Refer to page 156.)
REMARKS
â‹… If the setting dial and key operation are disabled, the monitor display is valid.
You can make the buzzer "beep" when you press key of the operation panel (FR-DU07) and parameter unit (FR-
PU04/FR-PU07).
Parameter
Number
Name Initial Value Setting Range Description
990 PU buzzer control 1
0 Without buzzer
1 With buzzer
Contrast adjustment of the LCD of the parameter unit (FR-PU04/FR-PU07) can be performed.
Decreasing the setting value makes contrast light.
Parameter
Number
Name Initial Value Setting Range Description
991 PU contrast adjustment 58 0 to 63
0 : Light
↓
63: Dark
To Next Page
Loading...
Need help?
General
