227
All parameter clear
4
PARAMETERS
4.24 All parameter clear
POINT
· Set "1" in ALLC parameter clear to initialize all parameters. (Parameters are not cleared when "1" is set in Pr.
77Parameter write selection. In addition, calibration parameters are not cleared.)
Setting Description
0 Not executed.
1 All parameters return to the initial values.
REMARKS
Refer to the list of parameters on page 288 for availability of parameter clear.
and are displayed alternately ... Why?
The inverter is not in the PU operation mode.
1. Press .
is lit and the monitor (4 digit LED) displays "0" (Pr. 79 = "0" (initial value)).
2. Carry out operation from step 6 again.
1.
Screen at powering on
The monitor display appears.
Display
Operation
3.
Press to choose the parameter
setting mode.
Flicker ··· Parameter setting complete!!
7.
Press to set.
5.
Press to read the currently set
value.
" "(initial value) appears.
PU indication is lit.
2.
Press to choose the PU operation
mode.
· Press to read another parameter.
· Press twice to show the next parameter.
· Press to show the setting again.
4.
Turn until (all parameter
clear) appears.
6.
Turn to change it to
the setting value " ".
The parameter
number read
previously appears.
To Next Page
Loading...
Need help?
General
