BODY REPAIR
BASE OF BODY REPAIR
9-32
Only the amounts of paint to be used for the day's work should
be in the work area; do not keep excessive amounts of paint, or
paint which is not going to be used, in the work area.
HEALTH AND SANITATION PROCEDURES
The following points should be noted for employee health and
sanitation.
• The work area should be well ventilated in order to prevent
the inhalation of dust, organic solvent vapors, etc.
• All unused paint cans must be securely covered.
• Care should be taken to avoid exposure to the skin of adhe-
sives, organic solvents, etc.
If an unavoidable exposure occurs, the exposed area
should be immediately washed with clean water.
VEHICLE PROTECTION
• Vehicle covers (fender covers, seat covers, etc.) and tape (if
there is the possibility of damage by tools, equipment, etc.)
should be used to protect painted surfaces, interior/exterior
parts and components, etc., from staining and damage.
• For welding operations, a heat-resistant protective cover
should be used to protect glass, seats, instrument panel,
carpeting, etc.
HEAT-WITHSTAND TEMPERATURES OF RESIN-PLASTIC PARTS
M4090016000010
Because resin-plastic parts are deformed by heat,
they should be removed if the heat to be applied is
high enough to cause deformation, as shown by the
table below.
AB200106
AB200107
MATERIAL NAME ABBREVIATION HEAT-DEFORMATION
TEMPERATURE °C (°F)
WHERE MAINLY USED
Acrylonitrile
styrene acrylate
ASA 80 (176) Door mirror, Pillar garnish, License
garnish, Radiator grille
Acrylonitrile
butadiene styrene
ABS 80 (176) Air spoiler, Console box, Radiator grille,
Rear garnish, Headlight bezel
Cellulose acetate CA 50 to 90 (122 to 194)
To Next Page
Loading...
Need help?
General
