Nikon T-RCP User Manual

I Preparations
2 Setting Attachment Information
- 17 -
I
(3) Filter Block
Set the information on filter blocks attached to the filter block changeover (motorized cassette holder).
1
Press the MODE key, and the SETTING MENU screen will
appear on the LCD.
Select “Filter” using the S key or the T key and then
press the [

] key.
ＳＥＴＴＩＮＧ ＭＥＮＵ
Ｏｂｊｅｃｔｉｖｅ
Ｃｏｎｄｅｎｓｅｒ
Ｆｉｌｔｅｒ
Ｅｘｃｉｔｅｒ
Ｂａｒｒｉｅｒ
Ｃｏｍｂｉｎａｔｉｏｎ（Ｏｂｊ．＞Ｃｏｎｄｅｎｓｅｒ）
Ｃｏｍｂｉｎａｔｉｏｎ（Ｆｉｌｔｅｒ＞ＥＸ／ＢＡ）
Ｍｏｒｅ
2
Select “Name” for the filter block using the PREV or NEXT
key.
Note:
The numbers at the left of the screen represent the
addresses of the filter block changeover.
ＦＩＬＴＥＲ
Ｎａｍｅ
１［
ＵＶ－１Ａ ］ ＥＸ ： ＥＸ３６５／１０
２［――――――――――］ ＤＭ ： ＤＭ４００
３［――――――――――］ ＢＡ ： ＢＡ４００
４［――――――――――］
５［――――――――――］
６［――――――――――］
Ｅｄｉｔ
3
Move to the next address of the filter block changeover
using the S key or the T key. Repeat step 2 above.
ＦＩＬＴＥＲ
Ｎａｍｅ
１［ＵＶ－１Ａ ］ ＥＸ ： ――――――――――
２［
――――――――――］ ＤＭ ： ――――――――――
３［――――――――――］ ＢＡ ： ――――――――――
４［――――――――――］
５［――――――――――］
６［――――――――――］
Ｅｄｉｔ
4
Press the MODE key to end the setting and to return to the
OPERATION screen.
Note:
If the filter block changeover is not connected, you cannot set the information on filter blocks.
“---------” indicates that no filter block is attached or registered at the address.
If a filter block attached is not in the presets, register it to the list of optional filter blocks. For details, see V-7 (3)
Filter Block in section V-7 (Registering Data for Optical Members).

Nikon T-RCP Specifications

General

Brand	Nikon
Model	T-RCP
Category	Remote Control
Language	English