NSM–3/3D
Service Software Instructions
PAMS Technical Documentation
Page 35
Issue 4 02/2002
Nokia Mobile Phones Ltd.
Base offset edit box:
This edit box shows the base offset value that the user can
change. The base level calculation check box must be checked
before this value is used. After this value is changed the user
must do the calculation.
NOTE: Do not use Enter button to accept this value.
+/– buttons (+/– and left/right cursor keys):
+ and – buttons will cause power changing by 0.25dB steps.
When these keys are used the coefficient value is updated on
the tuning window.
Save button (ENTER):
Dialog is closed and tuned values are
saved
to phone. Base
offset is saved to TESLA.INI.
Cancel button (ESC):
Dialog is closed and tuning
is not saved
to phone.
When selections are used, the power value checking is made and if it is
not successful, error message is shown. The test checks that all power
coefficients are in descending order (same order than power levels).
If the power tuning function is ended and EEPROM values are not re-
ceived or EEPROM fault is noticed, an error message is shown.
When all power coefficients have such values that they don’t cause any
error messages, they can be saved. The last used tuning power is in use
after exit.
The next automatic selection is made when this tuning function is ended:
Operation Mode = RX pulsed
When dialog is closed original band is selected.
To Next Page
Loading...
Need help?
General
