3-2 Extracting and Storing the File in the Memory Card
20
Step 4: Storing the I/O comment file in the Memory Card or PT.
●
Copying the I/O Comments File to the Memory Card
Store the extracted and converted I/O comment file in the ldrdata folder of the Memory
Card. (This procedure is given on the assumption that the ldrmt, procon, and ldrdata
folders under the ldrsetup folder on the CD-ROM are already copied to the Memory
Card.)
Copy the I/O comment files (G-@.ioc and L-@.ioc) to the ldrdata folder on the Memory
Card.
Note
The converted and extracted I/O comment file must be stored in the ldrdata folder on
the Memory Card. If the file is not stored in the correct location, the error message
“Cannot open I/O Comment file” will be displayed when the Ladder Monitor is started
and the I/O comments will not be displayed.
●
Copying the I/O Comments File to the PT
With Version-1 NS-series PTs and NSJ PLCs with NS system version 6.6 or higher, the
I/O comment file stored in the PT can be read by the Ladder Monitor.
1) On the computer, copy the converted Ladder Monitor I/O comment file to the project
folder for the PT using Explorer or another application.
2) Connect the computer to the PT.
3) Transfer the Ladder Monitor I/O comment file to the PT using a transfer program or the
CX-Designer. (Refer to Transferring Data to the PT in the CX-Designer online help for
information on the transfer program and CX-Designer.)
Note
• An I/O comment file stored in a Memory Card can also be read.
• If an I/O comment file with the same name is stored in both the Memory Card and
the PT, the I/O comment file in the PT will be read.
• With system version 6.5 or earlier, store the I/O comment file and Ladder Monitor
application in a Memory Card and place the Memory Card in the PT.
To Next Page
Loading...
Need help?
General
