46
If n001=5, a Run Command can be received even
while changing a constant. If sending a Run Com-
mand while changing a constant, such as during a test
run, be sure to observe all safety precautions.
Failure to observe this warning may result in injury.
MNTR Multi-function Monitoring
Selecting the Monitor
This function switches the operation: operation
using the Digital Operator including frequency
setting with potentiometer, operation using the
input terminals, or operation through communications.
Setting can be changed using the or key.
LOCAL/REMOTE Selection
(Local)
(Remote)
Constant No./data
Sets and changes data for a constant No.
Return to
(Refer to page 49 for details.)
If the V7AZ is stopped after
it has changed to any of
these modes during opera-
tion, it changes to Program
mode from Drive mode.
Even if the Run Command
is turned ON again, the
V7AZ does not operate.
However, if n001=5, the
Run Command can be
received and the V7AZ will
operate.
WARNING
Press the key. When is ON, data
can be displayed by selecting the monitor number.
Example: Monitoring the Output Voltage Reference
Select U-04 by
pressing the
or key.
Output voltage reference
is displayed.
or
To Next Page
Loading...
Need help?
General