Through-beam Sensor Heads: T Mode Functions Section 3-7
78
3-7-2 Inputting Threshold Values Directly
The threshold values can be directly input into the sub-display.
Note: Generally, any value can be input. The judgement outputs, however, will
not operate for thresholds that are outside the measurement range. Also,
the decimal point cannot be changed.
If an error occurs when inputting a threshold value, refer
to 4-4-2 Inputting Threshold Values Directly and 5-2-3
Unable to Set Threshold Values.
Z157-E1-01C.book Page 78 Thursday, August 31, 2006 5:13 PM
To Next Page
Loading...
Need help?
General
