Remove Front Indicator Panel
AppendixA • Servicing the Oracle Database Appliance Version 1 185
b.
If the system was installed in a rack, reinstall it into the rack.
See the Oracle Database Appliance Owner's Guide for instructions.
c.
Reconnect the power cords to the system and power on the system.
See “Powering On Oracle Database Appliance Version 1” on page 210.
Servicing the Front Indicator Panels (FRU)
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
The Oracle Database Appliance Version 1 front indicator panels contain the LEDs and
indicators on the front of the system. Each server node has its own front indicator panel, which
sits behind the ears on the system chassis.
The front indicator panels are FRUs and can only be replaced by an Oracle-qualified service
technician.
Caution - Equipment damage. Remove all power from the system before removing or
installing the front indicator panels. Power down both server nodes (also called system
controllers) and disconnect the power cords from the system before performing these
procedures. For instructions, see “Shutting Down a Server Node and Powering Off the
System” on page 109.
The following topics are covered in this section:
■
“Remove Front Indicator Panel” on page 185
■
“Install Front Indicator Panel” on page 188
Remove Front Indicator Panel
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes removing the front indicator panel from Oracle Database Appliance
Version 1.
To Next Page
Loading...
Need help?
General