Install Server Node Into System Chassis
208 Oracle Database Appliance Service Manual • June 2017
2.
Ensure that all six of the standoffs on the underside of the cover (three on each
side) fit into the slots on the top of the chassis side walls.
When the top cover is positioned (as described in previous step), the six standoffs on the
underside of the cover fit into the slots in the top of the chassis sidewalls.
3.
Slide the top cover toward the rear of the server node until it seats [2].
Installing a Server Node Into the System Chassis
If you removed a Oracle Database Appliance Version 1 server node from the chassis, perform
the following procedure to reinstall it.
Install Server Node Into System Chassis
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes installing a server node into the system chassis for Oracle Database
Appliance Version 1.
Note - Replacing a server node FRU with a new server node is a service activity that must be
performed by an Oracle-qualified service technician. The customer may remove the server node
to service other customer serviceable components in the server node.
To Next Page
Loading...
Need help?
General