Replace a Storage Shelf HDD or SSD (CRU)
58 Oracle Database Appliance Service Manual • June 2017
Note - After a physical insertion or removal action of a storage shelf component (such as a disk
or SAS cable), you should wait before performing the next action to allow the system software
to fully process the event. This could take several minutes to complete.
Servicing Storage Shelf Components
Oracle Database Appliance X3-2/X4-2 (DE2-24P), Oracle Database Appliance X5-2 (DE2-
24C), and Oracle Database Appliance X6-2-HA (DE3-24C) storage shelf components can all be
replaced while the storage shelf is powered-on and running. They include:
■
“Replace a Storage Shelf HDD or SSD (CRU)” on page 58
■
“Adding Optional Oracle Database Appliance X6-2-HA Storage Shelf Drives
(CRU)” on page 62
■
“Replace a Storage Shelf Power Supply (CRU)” on page 66
■
“Replace a Storage Shelf I/O Module (CRU)” on page 70
Replace a Storage Shelf HDD or SSD (CRU)
Note - After a physical insertion or removal action of a storage component (such as a disk or
SAS cable), you should wait before performing the next action to allow the system software to
fully process the event. This could take several minutes to complete.
1.
Locate the failed drive on the front of the storage shelf.
Look for the drive with its Service Required indicator and/or Ready-to-Remove indicator lit.
Caution - Equipment damage. Do not remove a drive unless you have an immediate
replacement.
2.
Remove the drive:
■
For the DE3-24C, press the release button [1] to release the drive lever. For the DE2-24C,
slide the release latch as indicated by the debossed arrow to release the drive lever. Then,
rotate the lever open and, grasping the drive body, slide the drive out of the storage shelf [2].
To Next Page
Loading...
Need help?
General