97
English
Network settings
Set when networking with a PC.
[Network settings] submenu will be displayed.
Network settings
Network control
BQ1-000
Off
Off
Display name
Network status
LAN setup
Serial control
AMX D. D.
Reset
OffAuto display name
Permit
USB memory network settings
PJLink settings
SERIAL IN
Protocol 2LAN control protocol
Administrator account settings
Off
Crestron Connected
™
■ [Administrator account settings]
Configure the administrator account settings.
Administrator account settings
Password policy
Save
Password
User name dispadmin
[Password policy]:
Precautions for password settings of this item will be
displayed in a new window.
[User name]:
The keyboard for setting the user name is displayed.
Enter the user name.
●
Entering characters (see page 154)
[Password]:
The keyboard for setting the password is displayed.
After entering the password, select [Ok]; the
confirmation screen is displayed. Enter the password
again and select [Ok]; the password is determined.
[Save]:
Saves the user name and password determined
above in the display unit.
Note
●
Once determined, it is necessary to enter the user
name and password to display the settings.
■ [Network control]
Set when controlling with the unit’s LAN terminal.
[Off]:
Invalidates control with LAN terminal.
(In this case, the power consumption of Standby
condition (when the power is turned off with the
remote control) will be slightly reduced.)
[On]:
Controls via LAN using the LAN terminal. The
power indicator lights purple when the power is
turned off with the remote control (standby).
Note
●
When using the LAN control function which is
described in “Using Network Function” (see page
110‒126), set this function to [On].
●
Even if the setting is set to [Off], the Web browser
control screens that do not control this unit (display
information [Status], detailed settings [Detailed set
up] and password change [Change password])
operate.
●
To set the setting to [On], you must configure
[Administrator account settings] in advance.
■ [PJLink settings]
Configure the PJLink settings to enable PJLink
communication on the unit.
PJLink settings
Password policy
Save
Password
PJLink control On
[Password policy]:
Precautions for password settings of this item will be
displayed in a new window.
[PJLink control]:
Specifies the PJLink communication settings.
Off:
Disables PJLink control.
On: Enables PJLink control.
[Password]:
The keyboard for setting the password is displayed.
After entering the password, select [Ok]; the
confirmation screen is displayed. Enter the password
again and select [Ok]; the password is determined.
●
Entering characters (see page 154)
[Save]:
Saves the password determined above in the display
unit.
Note
●
Once determined, it is necessary to enter the
password to display the settings.
●
To set the setting to [On], you must configure
[Administrator account settings] in advance.
●
To use PJLink control, you need to set [On] to the
setting and set [Network control] to [On].
●
The password for the setting is different from the
password for [LAN setup].
To Next Page
Loading...
Need help?
General