peplink 20 User Manual

USER MANUAL
Peplink Balance Series
4 Product Features
Peplink Balance Series products enableall LAN users to sharebroadband Internet connections,and
provide advanced features to enhanceInternet access. The following is the list of supported features:
4.1 Supported Network Features
4.1.1 WAN
 Multiple public IP support (DHCP, PPPoE, Static IP Address)
 10/100/1000Mbps Ethernet connection in Full/Half Duplex
 USB mobile connection(
Remark: Only one USB modem can be connected at a time.)
 Drop-in Modeon selectable WAN portwith MAC address passthrough(Available on Peplink
Balance 210+)
 Network Address Translation (NAT) / Port Address Translation (PAT)
 Inbound and Outbound NAT mapping
 Multiple static IP addresses per WAN Connection
 MAC address clone
 Customizable MTU and MSS values
 WAN connection health check
 Dynamic DNS (Supported service providers: changeip.com, dyndns.org, no-ip.org,tzo.com and
DNS-O-Matic)
 Ping, DNS Lookup and HTTP based health check
4.1.2 LAN
 DHCP server on LAN
 Static routing rules
 Local DNS proxy server
4.1.3 VPN
 Secure SpeedFusion
TM
(Available on Peplink Balance 210+)
 Bandwidth bonding &failover among selected WAN connections
 Ability to route traffic to a remote VPN peer
 Optional pre-shared key setting
 Layer 2 Bridging
 SpeedFusion
TM
Throughput, Ping and Traceroute Test
 Built-in PPTP VPN Server
 Authenticate PPTP clients by RADIUS and LDAP servers (Available on Peplink Balance 210+)
 IPsec VPN for Network-to-Network connection (Works with Cisco, Juniper only)
 PPTP and IPsecpassthrough
4.1.4 Inbound Traffic Management
 TCP/UDP traffic redirection to dedicated LAN server(s)
 Inbound link load balancing by means of DNS(Available on Peplink Balance 210+)
http://www.peplink.com -11 / 207 - Copyright © 2013 Peplink

peplink 20 Specifications

General

Brand	peplink
Model	20
Category	Network Router
Language	English