USER MANUAL
Peplink Balance Series
11.1.3 PPPoE Connection
This connection method is suitable if ISP provides login ID/ password to connect via PPPoE.
PPPoE Settings
PPPoE User Name
/ Password
Enter the required information in these fields in order to connect via PPPoE to the ISP.
The parameter values are determined by and can be obtained from the ISP.
Confirm PPPoE
Password
Verify your password by entering it again in this field.
Service Name
(Optional)
Service Name is a PPPoE parameter which is provided by the ISP.
Note: Leave this field blank unless it is provided by your ISP.
DNS Servers
Each ISP may provide a set of DNS servers for DNS lookups. This setting specifies the
DNS (Domain Name System) Servers to be used when a DNS lookup is routed through this
connection.
Selecting Obtain DNS server address automatically results in the DNS Servers assigned
by the PPPoE server to be used for outbound DNS lookups over the WAN connection.
(The DNS Servers are obtained along with the WAN IP address assigned from the PPPoE
server.)
When Use the following DNS server address(es) is selected, you can put custom DNS
server addresses for this WAN connection into the
and
fields.
Please refer to Section 11.3, 11.4, 11.5, and 11.6 for details about WAN Health Check, Bandwidth
Allowance Monitor, Additional Public IP Settings, and Dynamic DNS Settings respectively.
Note
PPPoE connection made from a firewall does not work with Drop-in mode.
http://www.peplink.com -61 / 207 - Copyright © 2013 Peplink
To Next Page
Loading...
Need help?
General
