USER MANUAL
Peplink Balance Series
15 Inbound Access
Inbound Access is also known as inbound port address translation. On NAT WAN connection, all inbound
traffic to the server behind Peplink unit requires Inbound Access rules.
By the custom definition of servers and services for inbound access,Internet users can access the servers
behind PeplinkBalance. Advanced configurations allow inbound access to be distributed among multiple
servers on the LAN.
Inbound Access applies only to WAN connections that operate under NAT mode. For WAN connections that
operate under drop-in mode or IP forwarding, inbound traffic is forwarded to the LAN by default.
15.1 Definition of Port Forwarding
(Available on Peplink Balance 20/30)
Inbound Port Forwarding rules are defined at: Network > Inbound Access >Port Forwarding
To define a new service, click the Add Service button upon which the following appears:
Enable
This setting specifies whether the Inbound Service takes effect.
With an Enable value of Yes, the inbound service takes effect: traffic is matched, and actions
are taken by Peplink Balance based on the other parameters of the rule.
With an Enable value of No, the inbound service does not take effect: Peplink Balance
disregards the other parameters of the rule.
Service Name
This setting identifies the service to the System Administrator.
Valid values for this setting consist only of alphanumeric and the underscore “_” characters.
http://www.peplink.com -92 / 207 - Copyright © 2013 Peplink
To Next Page
Loading...
Need help?
General
