USER MANUAL
Peplink Balance Series
4.1.5 Outbound Policy
Link load distribution per TCP/UDP service
Persistent routing for specified source and/or destination IP addresses per TCP/UDP service
Prioritize and route traffic to VPN tunnels with Priority and Enforced algorithms
4.1.6 WLAN Controller
• Configure and manage Pepwave AP devices
• Review the status of connected AP
4.1.7 QoS(Available on Peplink Balance 210+)
Quality of Service for different applications and custom protocols
User Group classification for different service levels (Available on Peplink Balance 380+)
Bandwidth usage control and monitoring on group- and user- level (Available on Peplink
Balance 380+)
Application Prioritization for custom protocols and DSL optimization
4.1.8 Firewall
Outbound (LAN to WAN) firewall rules
Inbound (WAN to LAN) firewall rules per WAN connection
Intrusion detection and prevention
Specification of NAT mappings
Web Blocking (Available on Peplink Balance 380+)
Outbound firewall rules can be defined by destination domain name
4.2 Other Supported Features
Easy-to-use web administration interface
HTTP and HTTPS support for Web Administration Interface
Configurable web administration port and administrator password
Read-only user for Web Admin
Authentication and Accounting by RADIUS server for Web Admin(Available on Peplink Balance
210+)
Firmware upgrades, configuration backups, Ping, and Traceroute via Web Administration
Interface
Remote web based configuration (via WAN and LAN interfaces)
Remote reporting to Peplink Balance reporting server
Hardware High Availability via VRRP, with automatic configuration synchronization(Available on
Peplink Balance 210+)
Real-Time, Hourly, Daily and Monthly Bandwidth Usage reports and charts
Hardware backup via LAN bypass (Available on Peplink Balance 580, 710, 1350 and 2500)
Built-in WINS server
Time server synchronization
SNMP
Email notification
Syslog
SIP passthrough
http://www.peplink.com -12 / 207 - Copyright © 2013 Peplink