peplink 20 User Manual

USER MANUAL
Peplink Balance Series
16 NAT Mappings
The configuration of NAT Mappings allows the IP address mapping of all inbound and outbound
NAT’edtraffic to and from an internal client IP address.
The settings to configure NAT Mappings are located at:Network>NAT Mappings
To add a rule for NAT Mappings, clickAdd NAT Rule, upon which the following screen will be displayed:
NAT Mapping Settings
LAN Client(s)
NAT Mapping rules can be defined for a single LAN IP Address, an IP Range, or an IP
Network.
Address
This refers to the LAN host’s private IP address.The system maps this address to a
number of public IP addresses, specified below, in order to facilitate inbound and
outbound traffic.
This option is only available when IP Address is selected.
Range
The IP range is a contiguous group of private IP addresses used by the LAN host. The
system maps these addresses to a number of public IP addresses, specified below, to
facilitate outbound traffic.
This option is only available when IP Range is selected.
Network
The IP network refers to all private IP addresses and ranges managed by the LAN host.
The system maps these addresses to a number of public IP addresses, specified below,
to facilitate outbound traffic.
This option is only available when IP Network is selected.
http://www.peplink.com -115 / 207 - Copyright © 2013 Peplink

peplink 20 Specifications

General

Brand	peplink
Model	20
Category	Network Router
Language	English