USER MANUAL
Peplink Balance Series
18 QoS
18.1 User Groups
(Available on Peplink Balance 305 and380+)
LAN and PPTP clients can be categorized into three user groups - Manager, Staff, and Guest.This table
allows you to define rules and assign client IP addresses or subnets to a user group. You can apply
different bandwidth and traffic prioritization policies on each user group in the Bandwidth
Control and Application sections.
The table is automatically sorted, and the table order signifies the rules' precedence.The smaller and
more specific subnets are put towards the top of the table and have higher precedence; larger and less
specific subnets are placed towards the bottom.
Click the Add button to define clients and their user group. Click the button to remove the defined
rule.
Two default rules are pre-defined and put at the bottommost.They are All DHCP reservation
clients and Everyone, and they cannot be removed. The All DHCP reservation client representsthe
LAN clients defined in the DHCP Reservation table in the LAN settings page. Everyone represents all
clients that are not defined in any rule above. Click on a rule to change its group.
Add / Edit User Group
Subnet / IP Address
From the drop-down menu, choose whether you are going to define the client(s) by an IP
Address or a Subnet.
If IP Address is selected, enter a name defined in DHCP Reservation table or a LAN
client's IP address. If Subnet is selected, enter a subnet address and specify its subnet
mask.
Group
This field is to define which User Group the specified Subnet / IP Address belongs to.
Once users have been assigned to a user group, their internet traffic will be restricted by rules defined for
that particular group. Please refer to the following two sections for details.
http://www.peplink.com -138 / 207 - Copyright © 2013 Peplink
To Next Page
Loading...
Need help?
General
