173
Menu Mode
5.3 Menu Mode
5.3.1 About menu mode
1) Entering/leaving the menu mode
• Pressing the [MENU] button on the remote control or main-control panel in the normal-operation mode causes the
menu screen to appear.
Pressing the [MENU] button while in the menu mode causes the menu to close.
2) When performing adjustment in the menu mode...
• The signal and screen adjustment values are saved in memory for each input function and input signal. For details,
refer to section 5.4.4, “PICTURE, White Balance and SCREEN Position Adjustment Values Memory Area Tables”
(pg. 257).
3) Precautions
(1) In the following cases, the menu closes automatically:
• Input is switched
• No operation for approximately three minutes
(2) For details about menu adjustments, refer to the Operating Instructions.
(3) It is recommended that adjustment and settings be performed with signal that will actually be input.
(4) The items that can be adjusted and set differ according to the input signal. Also, changing settings is only
possible when no video signal is input.
5.3.2 Concerning the display of the OSD of each item
Example of Menu Display:
SCREEN SETUP OPTION
:
0
:
0
:
0
CONTRAST
:
0
BRIGHTNESS
H.ENHANCE
V.ENHANCE
PICTURE RESET
PICTURE
MENU INPUT1
ENTER
SET
EXIT
MENU
Images shown here may differ from the actual display image.
To Next Page
Loading...
Need help?
General