8.16
FINAL DRIVE
11. Remove the vent line and the (4) bolts securing the front
gearcase to frame.
12. Lay the gearcase on its side (vent side up) and rotate it in
the frame so the input shaft is facing you.
13. Remove the gearcase from the front LH wheel well area and
carefully slide it between the upper and lower A-arms.
Gearcase Disassembly / Inspection
1. Drain and properly dispose of used lubricant. Remove any
metal particles from the drain plug magnet.
2. Remove the (4) screws retaining the piston pump assembly
to the gearcase and remove the pump.
NOTE: Piston pump assembly is a non-serviceable
item and should not be disassembled. Replace as an
assembly if found to be damaged or non-working.
3. Remove the (6) screws retaining the cover plate assembly
and open the wire retaining clip.
Retaining
Clip
PartShark.com
877-999-5686
To Next Page
Loading...
Need help?
General
