12.11
ELECTRICAL
12
REVERSE OVERRIDE /
MODE BUTTON
Function Test
Use a multimeter to test for continuity when pressing the
Reverse Override / Mode button.
Push the Reverse Override / Mode button. There should be
continuity between pins B and C.
If the test fails, replace the LH control assembly.
HEAD LAMP SWITCH
Function Test
Use a multimeter to test for continuity with the 3 head lamp
control outputs (OFF / LOW / HIGH) in the LH control
assembly.
There should be no continuity on any pin when the headlamp
switch is in the OFF position.
Move the switch to LOW. There should be continuity between
pins D and F.
Move the switch to HIGH. There should be continuity between
pins D and E.
If any of the tests fail, replace the LH control assembly.
Reverse Override / Mode Button Test
BC
FREE
PUSH
B
C
Headlamp Switch Test
DEF
OFF
LOW
HIGH
D
E
F
PartShark.com
877-999-5686
To Next Page
Loading...
Need help?
General
