Polaris 2009 Sportsman XP 850 User Manual

5.3
ENGINE
5
GENERAL INFORMATION - ENGINE
Special Tools
Engine Lubrication Specifications
Oil Pressure Test
1. Remove center Main Oil Gallery plug (A) from right side
of upper crankcase.
2. Insert a 1/4” NPT oil pressure gauge adaptor and oil
pressure gauge.
3. Start engine and allow it to reach operating temperature,
monitoring gauge indication.
NOTE: Test results are based on the use of the
recommended engine oil at operating temperature,
and may vary considerably if any other oil is used or
if engine is not up to temperature.
Tool Description Part Number
CRANKSHAFT HOLDING TOOL PA-49318
CRANKSHAFT SEAL INSTALLER PA-49320
FLYWHEEL / WATER PUMP DRIVE NUT PULLER PA-49316
FUEL PRESSURE TEST ADAPTOR PS-48762
MITY VAC
‘ PRESSURE TEST TOOL 2870975
OIL FILTER WRENCH PU-50105
PISTON RING COMPRESSOR PLIERS PV-43570-1
PISTON RING COMPRESSOR BAND - 87mm PV-43570-3
UNIVERSAL DRIVER HANDLE PU-45543
VALVE SPRING COMPRESSOR PV-1253 or PV-4019 (Quick Release)
VALVE SPRING COMPRESSOR ADAPTOR PV-43513-A
WATER PUMP BEARING AND COUPLER PRESS PA-49378
WATER PUMP DRIVE NUT / FLYWHEEL PULLER PA-49316
WATER PUMP MECHANICAL SEAL INSTALLER PA-44995-A
=
Capacity - Approximately 2 U.S. Quarts (1.9 l)
Oil Type - Polaris PS4 Plus 2W-50 Synthetic
Filter Wrench - PV-43527 or equivalent
Oil Pressure Specification - 10-25 PSI @ Idle RPM (using Polaris PS4 Plus 2W-50 Synthetic), Engine at
operating temperature.
A
Oil Pressure at Idle RPM (Engine Hot):
Standard: 25 PSI
Minimum: 10 PSI
PartShark.com
877-999-5686

Polaris 2009 Sportsman XP 850 Specifications

General

Brand	Polaris
Model	2009 Sportsman XP 850
Category	Offroad Vehicle
Language	English