12.8
ELECTRICAL
Method 2
1. With the ignition key in the OFF position, press and hold
the MODE button.
2. While still pressing the MODE button, turn the ignition key
to the ON position. Continue holding the MODE button
until the time begins to flash.
3. Follow steps 3 - 5 in METHOD 1 to set the clock.
Units of Measurement
To change between Standard and Metric units of measurement,
follow these steps:
1. Toggle the MODE button until the vehicle speed is
displayed on the screen.
2. Toggle the SELECT button until the odometer is displayed
in the information area.
3. Press and hold the MODE button until the units of
measurement in the speedometer area change (MPH to km/
h or km/h to MPH).
4. Release the button when the desired setting is achieved. All
units including vehicle speed, odometer/ trip meters, and
clock will be set to the desired Standard or Metric units.
Diagnostic Mode
Use the following procedure to display diagnostic trouble codes
logged in the ECU if the check engine MIL is illuminated on the
instrument cluster.
1. Place the transmission in PARK.
2. Push and release the SELECT button to toggle through the
LCD display until the check engine MIL icon is flashing.
3. When the check engine MIL icon is flashing, a set of two
numbers will appear on the LCD.
4. The first number is located in the information area and can
be 2 to 6 digits in length. This number equates to the
suspected area of fault.
5. The second number will appear in the clock area and can 1
to 2 digits in length. This number equates to the fault mode.
6. Use the trouble code reference table in the EFI Chapter for
a description of each code.
7. Press and hold the MODE button to cycle through all
currently active codes.
NOTE: On vehicles equipped with power steering,
the power steering MIL LED will illuminate and blink
in place of the check engine MIL if there is a
diagnostic problem with the power steering system.
PartShark.com
877-999-5686
To Next Page
Loading...
Need help?
General
