4
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
4.23
VENT LINE TERMINATION FITTING
This fitting should be inspected and tested using a Mity
Vac™ to ensure proper venting. Connect the Mity Vac to
the fitting and give it 5 pumps. The gauge should return
to 0 immediately or there is an obstruction.
NOTICE
If the vent line fitting is removed from the frame, it must
be replaced. The ears on the clip (arrows) will not hold
properly once it is removed.
FUEL LINE QUICK CONNECT REMOVAL
When properly used, fuel line quick connects can be
disconnected and reconnected multiple times for vehicle
service needs. If the quick connect is damaged, it is not
designed to be serviceable and the fuel line assembly
will require replacement.
There are two methods of disconnecting Fuel line quick
connects, the preferred method is by using a small
straight blade screwdriver.
Screwdriver Method:
1. Insert a #1 flat blade screw driver into the pry slot on
the top of the retaining clip.
CAUTION
To prevent damage to the retaining clip, be sure to use
a flat blade screwdriver that fits into the pry slot.
2. Gently pry the retaining clip upwards into the open
position.
3. Remove quick connect from the fuel fitting.
Hand Method:
FUEL SYSTEM
To Next Page
Loading...
Need help?
General
