11
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
11.31
RIDER INFORMATION DISPLAY
The rider information display is located in the instrument
cluster. All segments will light up for 1 second at start-up.
NOTICE
If the instrument cluster fails to illuminate, a battery
over-voltage may have occurred and the instrument
cluster may have shut off to protect the electronic
speedometer.
1. Vehicle Speed Display - Analog display of vehicle
speed in MPH or km/h.
2. Information Display Area - Odometer / Trip Meter /
Tachometer / Engine Temperature / Engine Hours
/ Service Info / Clock - LCD display of the service
hour interval, total vehicle miles or km., total engine
hours, a trip meter, engine RPM and engine
temperature.
3. MPH / KM/H Display - MPH is displayed when the
instrument cluster is in the Standard mode. KM/H is
displayed when the instrument cluster is in the Metric
mode.
4. High Beam Indicator - LED icon illuminates
whenever the headlight switch is in the high beam
position.
5. Fuel Level Indicator - LCD bar graph indicating
current fuel level.
6. Clock - Displays current time in either 12-hour or 24-
hour formats.
7. Engine Temperature Indicator - Illuminates when
the ECU determines the engine is overheating. The
indicators will initially flash to indicate the engine is
overheating. The indicators will stay lit and not flash if
a severe overheating condition exists.
8. Service Interval Indicator - Preset at the factory and
adjustable by the user, a flashing wrench symbol
alerts the operator that the preset service interval has
been reached and maintenance should be performed.
The wrench icon will flash for 10 seconds upon start-
up once it reaches 0.
9. Check Engine MIL - Illuminates when the ECU has
detected a Diagnostic Trouble Code in the engine
management system.
10.AWD Indicator - Illuminates when the AWD / TURF
switch is in the AWD position.
11. Neutral Gear Indicator - Illuminates when gear
selector is in the neutral (N) position.
12.Gear Position Indicator - Displays gear selector
position.
H = High
L = Low
N = Neutral
R = Reverse
P = Park
– = Gear Signal Error (shifter stuck between gears)
13.Power Steering System MIL - Illuminates when a
fault has occurred with the power steering system.
This indicator illuminates when the key is turned to
the ON position and goes off when the engine is
started.
14.Turn Signal / Hazard Lamp Indicator - Illuminates
whenever the LH, RH or hazard lamps are activated
(INT’L Models Only).
15.Helmet / Seat Belt Indicator - Illuminates for several
seconds when the key is turned to the ON position.
The lamp is a reminder to the operator to ensure all
riders are wearing helmets and seat belts before
operating the vehicle.
16.ADC Indicator - Illuminates when Active Descent
Control (ADC) is selected.
17.Performance Limited Indicator - Illuminates when
engine performance is electronically limited.
18.Low Fuel Indicator - Illuminates when fuel level
reaches lowest bar on fuel level indicator.
19.Engine Speed Display - Analog display of engine
speed in thousands of revolutions per minute.
20.Parking Brake Indicator - Illuminates when parking
brake is engaged (INT’L Models Only).
21.Low Battery Indicator - Illuminates when battery
voltage drops below 8.5 Volts.
RIDER INFORMATION DISPLAY (INTL)
The rider information display is located in the instrument
cluster. All segments will light up for 1 second at start-up.
NOTICE
If the instrument cluster fails to illuminate, a battery
over-voltage may have occurred and the instrument
cluster may have shut off to protect the electronic
speedometer.
1. Vehicle Speed Display - Analog display of vehicle
speed in MPH or km/h.
ELECTRICAL
To Next Page
Loading...
Need help?
General
