To Next Page

To Previous Page

9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual

7.45

BEARING INSTALLATION

1. Thoroughly clean the rear bearing carrier housing

and the outer race on the new bearing. Be sure that

all oil residue has been removed from each surface.

2. Support the bottom of the bearing carrier housing.

CAUTION

Use an arbor and press only on the outer race,

otherwise bearing damage may occur.

3. Apply Loctite

603

™

retaining compound to the outer

circumference of the new bearing race

and

carefully press the new bearing into the bearing

carrier housing

NOTICE

Use care to not allow any of the Loctite

compound to

get in the bearing.

4. Wipe the housing clean of any excess compound and

install the snap ring

REAR BEARING CARRIER INSTALLATION

1. Install drive shaft through the backside of the bearing

carrier.

2. Install rear bearing carrier onto control arms and

mounting fasteners. Torque fasteners to specification.

TORQUE

Rear Bearing Carrier Mounting Fasteners:

42 lb-ft (57 Nm)

3. Apply anti-seize to drive shaft splines.

4. Install rear wheel hub assembly

, install cone

washer with domed side out

, and hand tighten the

castle nut.

NOTICE

2016–2017 models have two cone washers

FINAL DRIVE

Polaris GENERAL 2016 User Manual

Questions and Answers: