To Next Page

To Previous Page

9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual

7.17

PROPSHAFT REMOVAL - GENERAL 4

(2018)

1. Raise and support the vehicle.

WARNING

Serious injury may result if machine tips or falls. Be

sure machine is secure before beginning this

procedure. Always wear eye protection.

2. Remove skid plate from the vehicle. Refer to “Skid

Plate Replacement”page 10.73 procedure.

3. Locate the propshaft roll pin and use the Roll Pin

Removal Tool (2872608) to remove the roll pin.

Discard roll pin. Push the front propshaft rearward to

remove it from the front gearcase input shaft.

4. Slide the front propshaft

off the center propshaft

and remove it from the vehicle.

CAUTION

Use care not to damage brake lines when removing

propshafts.

5. Remove the fasteners retaining center propshaft

support bearing to the frame.

6. Slide the center propshaft off the rear propshaft, and

remove it from the vehicle.

7. Remove the fasteners retaining the rear propshaft

support bearing to the frame.

NOTICE

Note the orientation of the coolant line clip for

installation.

FINAL DRIVE

Polaris GENERAL 2016 User Manual

Questions and Answers: