11.82
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
SWITCH SERVICE
BRAKE PRESSURE SWITCH
The brake pressure switch
q
is located on the front
brake line banjo bolt of the master cylinder. The brake
switch may be accessed easily through the front LH
wheel well.
TESTING
1. Disconnect wire harness from switch and connect an
ohmmeter across switch contacts. The reading
should be infinite (OL).
2. Apply the brake and check for continuity. If there is no
continuity, or if resistance is greater than 0.5 ohms,
clean the switch terminals. Re-test and replace switch
if necessary.
REPLACEMENT
NOTICE
Brake fluid will leak out of the master cylinder when the
brake switch is replaced. Place a suitable catch
container/rags below the master cylinder prior to brake
switch removal.
1. Disconnect the harness going to the brake switch.
2. Loosen and remove the brake switch.
3. Install new brake switch. Torque brake switch to
specifications.
TORQUE
Brake Switch:
15 lb-ft (20 Nm)
4. Bleed the brake system. Refer to “Brake Bleeding /
Fluid Changepage 9.35” procedure.
ELECTRICAL
To Next Page
Loading...
Need help?
General
