11.88
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
WINCH SWITCH TESTING
1. Disconnect the winch switch harness on the back
side of the center console by depressing the
connector locks and pulling on the connector. Do not
pull on the wiring.
2. Test between the 3 sets of outputs (ON / OFF / ON). If
any of the tests fail, replace winch switch assembly.
• Move the switch to Position 1, ON. There should be
continuity (< 1 Ω) between switch pins 2 and 3.
• Move the switch to Position 2, OFF. There should
be NO continuity (∞ - OL) between switch pins 2
and 3; 1 and 2.
• Move the switch to Position 3, ON. There should be
continuity (< 1 Ω) between switch pins 1 and 2.
ELECTRICAL
To Next Page
Loading...
Need help?
General
