To Next Page

To Previous Page

9.18

9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual

5. Plug in the wheel speed sensor into the HECU.

6. Route the wiring down to the sensor bracket.

7. Insert the sensor into the bracket.

8. Install the fastener and torque to specification.

TORQUE

ABS Sensor Fastener (INTL):8 lb-ft (11 Nm)

9. Adjust the wheel speed sensor air gap. See Wheel

Speed Sensor Air Gap Adjustment (INTL)page 9.18

WHEEL SPEED SENSOR AIR GAP

ADJUSTMENT (INTL)

For the ABS system to work properly the gap between

the tone ring and sensor must be set to a specific value.

Adjusting wheel speed must be done for all four sensors.

Two sensors are located on the right and left hand side of

the transmission. Two sensor are located on right and left

hand side of the front gearcase.

Air Gap Specification 0.8–1.0 mm

1. Loosen the Allen head fasteners

securing the

wheel speed sensor bracket to the gearcase.

NOTICE

The wheel speed sensor bracket fastener holes are

slotted for easy adjustment and do not require the

fasteners to be removed. The fasteners must be loose

enough that the bracket is able to move freely up and

down.

2. Insert a feeler gauge of the correct specification

between the sensor and the tone ring.

BRAKE SYSTEM

Polaris GENERAL 2016 User Manual

Questions and Answers: