Polaris GENERAL 2016 User Manual

6.20
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
12. Lift up on the shift shaft rail (Q) and move the rail
assembly rearward to allow the shift fork pins to be
removed from the shift drum (R). Remove the shift
drum (R) from the transmission housing.
13. Remove the shift shaft rail (Q) and shift forks from
the transmission housing as an assembly.
14. Remove the rear output shaft assembly (S) by lifting
underneath the gear or by tapping the shaft from the
opposite side. If use of a pry bar is necessary, take
care not to pry on sealing surfaces of case.
15. Remove the idler gear shaft assembly (T) and gear
cluster assembly (U) from the transmission housing
by pulling both assemblies straight up.
16. Place the idler gear shaft assembly (T) and gear
cluster assembly (U) on a clean surface for
inspection. If disassembly is required, refer to “Gear
Cluster Disassembly”page 6.21.
17. Slide engagement dog (X) off of shift fork guides.
TRANSMISSION

Polaris GENERAL 2016 Specifications

General

Brand	Polaris
Model	GENERAL 2016
Category	Offroad Vehicle
Language	English