6
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
6.39
20.Install a new O-ring on each shift shaft. Apply a small
amount of white lithium grease on the O-rings, shift
shafts and component contact surfaces prior to
installing the sector cover.
21.Clean the transmission and gear sector cover mating
surfaces thoroughly.
22.Apply Crankcase 3-Bond Sealant (PN: 2871557) onto
the cover and transmission case mating surface.
23.Install the sector cover and align the transmission
case dowel with the alignment hole. Install and torque
the bolts to specification.
TORQUE
Sector Cover Bolts: 9–12 lb-ft (12–16 Nm)
Fill / Drain Plug: 10-14 lb-ft (14-19 Nm)
Bellcrank Nut: 12–18 lb-ft (16–24 Nm)
24.Install the transmission drain plug and torque to
specification.
25.Install the bellcrank onto the shift shaft. Note the key
splined on the bellcrank and shift shaft. Install the nut
and torque to specification.
26.Refer to Transmission Installationpage 6.12 to
complete the repair.
TRANSMISSION
To Next Page
Loading...
Need help?
General
