GENERAL INFORMATION
2.25
ENGINE OIL LEVEL
The oil tank is located on the left side of the vehicle.
To check the oil level:
1. Set machine on a level surface.
2. Start and run engine for 20-30 seconds. This will
return oil to its true level in the oil tank. About a
cup of oil will remain in the crankcase.
3. Stop engine, remove the bench seat.
4. The oil tank is located on the driver side. Remove
dipstick and wipe dry with a clean cloth.
Dipstick
5. Reinstall dipstick, screwing into place.
NOTE: The dipstick must be screwed completely in
to ensure accurate measurement.
ADD 8 OZ. NORMAL FULL
Maintain Oil Level In Normal Range
Screw in completely to check
6. Remove dipstick and check to see that the oil
level is in the normal range. Add oil as indicated
by the level on the dipstick. Do not overfill.
NOTE: Rising oil level between checks in cool
weather driving, can indicate moisture collecting in the
oil reservoir . If the oil level is over the full mark,
change the oil.
OIL AND FILTER CHANGE
WARNING
Personal injury can occur when
handling used oil. Hot oil can cause
burns or skin damage.
NOTICE:
Care must be taken to ensure that fluids are
contained. Be prepared to collect the fluid
with suitable containers before opening any
compartment or disassembly any compo-
nent containing fluids.
Poaris Premium Synthetic OW--40
(PN 2 871281) (Quart)
Ambient Temperature Range:
-- 4 0 ° F to 120° F
RECOMMENDED ENGINE OIL:
1. Place vehicle on a level surface.
2. Run engine two to three minutes until warm. Stop
engine.
3. Clean area around drain plug (B) at bottom of oil
tank.
4. Place a drain pan beneath oil tank and remove
drain plug. CAUTION: Oil may be hot. Do not
allow hot oil to come into contact with skin as
serious burns may result.
5. Allow oil to drain completely.
6. Replace sealing washer (A) on drain plug. NOTE:
The sealing surfaces on drain plug and oil tank
should be clean and free of burrs, nicks or
scratches.
B
A
C
D
7. Reinstall drain plug and torque to 14 ft. lbs. (19
Nm).
8. Loosen clamp (D).
9. Remove oil hose from screen fitting (C) on bottom
of oil tank.
To Next Page
Loading...
Need help?
General
