To Next Page

To Previous Page

9926814 R08 - 2015-2016 RZR 900 2016 RZR S 1000 Service

Manual

9.17

FRONT BRAKES

FRONT CALIPER / PAD REMOVAL

1. Elevate and support front of vehicle.

WARNING

Use care when supporting vehicle so that it does not tip

or fall. Severe injury may occur if machine tips or falls.

2. Remove the wheel nuts and front wheel.

3. Loosen the pad adjuster screw 2-3 turns

4. Remove the upper and lower caliper mounting bolts

and remove the caliper from the front hub.

NOTE

When removing caliper, use care not to damage brake

line. Support caliper to avoid kinking or bending brake

line.

5. Push caliper piston into caliper bore slowly using a C-

clamp or locking pliers with pads installed.

NOTE

Brake fluid will be forced through compensating port

into master cylinder fluid reservoir when piston is

pushed back into caliper. Remove excess fluid from

reservoir as required.

6. Push the mounting bracket inward and slip the outer

brake pad out between the bracket and caliper body.

7. Remove the inner pad from the bracket and caliper.

BRAKE SYSTEM

Polaris RZR S 1000 2016 User Manual

Questions and Answers: