Polycom Trio Visual+ User Manual

Hardware and Accessories
Polycom, Inc. 149
● Maximum peak power to the loudspeaker is limited.
Power the Polycom Trio System with the Optional
Power Injector
If your building is not equipped with PoE+ you can use the optional power injector to enable full functionality
on your Polycom Trio 8800 and 8500 system.
If you are using the power injector to power the Polycom Trio 8800 and your setup includes the Polycom
Trio Visual+, connect the Polycom Trio 8800 in the following sequence before powering up the Polycom Trio
8800 and Visual+.
1 Plug the AC power cord of the power injector into the wall and use a network cable to connect the
power injector to the Polycom Trio 8800.
2 Connect the power injector to the network with a CAT-5E or CAT-6 Ethernet cable.
The power adapter LED is green when the Polycom Trio 8800 is correctly powered. If the LED is
yellow, the power injector is bypassed and the Polycom Trio system is drawing PoE power from the
outlet.
3 If the power injector LED is yellow, turn off the PoE network port or connect the Polycom Trio
solution in the following sequence:
a Power up Polycom Trio 8800 and Visual+ using the power injector but do not plug the devices into
the network wall port.
b Wait for the Polycom Trio 8800 and Visual+ systems to boot up
c Plug the devices into the network wall port.
d Ensure the LED indicator on the power injector is green.
Pairing the Polycom Trio Visual+ with Polycom
Trio
Pair the Polycom Trio Visual+ with Polycom Trio 8500 or 8800 system to enable video calls and content
sharing. You can pair only one Polycom Trio Visual+ to a Polycom Trio 8500 or 8800 system. Polycom
recommends you plug both devices into a local gigabit switch.
You can pair the Polycom Trio Visual+ to the Polycom Trio system using configuration files or from the
Polycom Trio menu system. To pair, the Polycom Trio system and Polycom Trio Visual+ must be connected
to the same subnet and you must unblock the following network components:
● Multicast address 224.0.0.200
● Port 2000
Note: If the Polycom Trio Visual+ loses power after a Polycom Trio 8800 reboot, unplug both devices
and repeat steps 1 and 2.

Polycom Trio Visual+ Specifications

General

Brand	Polycom
Model	Trio Visual+
Category	Conference System
Language	English