2. Select Internet (LAN) and press [OK].
See also
• To physically connect the LAN to the base, see Connection Diagram on page 18.
How to Set LAN Parameters
LAN settings can only be performed if the machine was actually connected to the LAN
at power-up.
To set the parameters of the LAN:
1. As supervisor (see How to Log in as Supervisor on page 180):
From the main menu, select the path: Communication Settings Internet (LAN)
Settings
The DHCP configuration is displayed.
2. Select Auto to automatically configure the LAN (recommended).
Otherwise, select Manual to set parameters manually.
3. Press [OK] four times for a standard LAN configuration.
210
| Page 210 | Jan-27-2023 01:28 |
10
Configuring your Mailing System
To Next Page
Loading...
Need help?
General
