97
ESP-LXME Controller
G
To remove the front panel: disconnect the ribbon cable from the
front panel by gently pulling the connector out of the socket.
CAUTION: Be careful not to bend the pins in the sockets when
attaching or detaching the ribbon cable.
H
Rock the front panel upward and nudge the bottom corner pin
out of the lower pin-hole to remove the front panel.
7
8
Remove Modules
Every ESP-LXME Controller ships with two modules packaged inside
the cabinet, one base module (Base or Flow Smart) and one station
module (SM8 or SM12). The types of modules that are included depend
on the variant of ESP-LXME.
A
Remove both the modules and cardboard packaging from inside
the controller and set the modules aside for installation later.
B
The top-most box contains either the Base or Flow Smart Module,
with multi-color label visible through the box window.
C
The bottom-most box contains either an 8 or 12 Station Module,
with solid blue color label visible through the box window.
2
3
To Next Page
Loading...
Need help?
General
