23
ESP-LXME Controller
Program Run Time
Review total Run Time for an individual program:
Turn the controller dial to Test All Stations/Check System.
A
The Check System screen appears with Conrm Programs
selected; press Next.
B
The Conrm Programs screen appears. Press the Down Arrow
button to select Program Run Time; then press Next.
1 2
C
The Total Run Time screen appears and total Run Time is displayed
for the currently selected program.
NOTE: If the desired program is not selected, use the Program
Select switch to change it. See Section B, Program Select Switch
for more details.
3
NOTE: For stations set up for Cycle+Soak, the Cycle Time (when
irrigation is occurring) will be included in Program Run Time
calculations but Soak times will NOT be included. See Section D,
Set Up Cycle+Soak, for more details.
NOTE: The total program run time is the cumulative total run
time if stations are run one at a time. If SimulStations have been
set to more than 1, total irrigation time will be less.
Change the Program Select switch and repeat this process to
review and conrm Program Run Times for other programs as
desired.
To Next Page
Loading...
Need help?
General
