39
ESP-LXME Controller
Weather Sensor Setup
Turn the controller dial to Delay Watering.
A
The Delay Watering screen appears. Press the Down Arrow button
to select Weather Sensor; then press Next.
B
The Weather Sensor Setup screen appears. Press the + and –
buttons to set the weather sensor type; then press Next.
1 2
C
Press the + and – buttons to set the Settling Time; then press Next.
NOTE: Settling time is how long a weather condition must last
before the controller takes action. For example, if a freeze sensor
has a 5 minute settling time then the temperature would have
to remain below the sensor’s threshold set point for 5 minutes
before irrigation is paused. Settling time can be set for immediate
(0 seconds) or up to 10 minutes long.
3
NOTE: The weather sensor is turned on (Active) or o (Bypassed)
using the Weather Sensor switch on the controller front panel.
To Next Page
Loading...
Need help?
General
