18
ESP-LXME Controller
Station Run Times
Run Times are the number of minutes (or hours and minutes) that
each station runs.
Station Run Times are particular to programs; so typically stations are
set for a single program.
Turn the controller dial to Set Station Run Times.
A
The Set Run Times screen appears. Press the + and – buttons on
the left to select the station to program.
NOTE: If the desired program is not selected, use the Program
Select switch to change it. See Section B, Program Select Switch
for more details.
B
Press the + and – buttons on the right to set the Station Run Time.
Range can be from 00 minutes (no Run Time) up to 24:00 hours.
Press and HOLD buttons to accelerate settings for hours and
minutes.
1 2
Change the Program Select switch and repeat this process to set
up additional Station Run Times for other programs as desired.
NOTE: Seasonal Adjust % adjustments will adjust the Station Run
Time down to the second. For example, if the Run Time is set for 1
minute and the Seasonal Adjust % is set to 50% then the adjusted
Run Time equals 30 seconds.
To Next Page
Loading...
Need help?
General
