25
ESP-LXME Controller
Test All Stations
You can test all stations connected to your controller by running each
of them in station number sequence.
Sometimes this is useful after installation, for general maintenance or
as a rst step in troubleshooting your system.
NOTE: Only stations with programmed run times are included in
the Test All Stations operation.
Turn the controller dial to Test All Stations/Check System.
A
The Check System screen appears. Press the Down Arrow button
to select Test All Stations; then press Next.
B
The Test All Stations screen appears. Press the + and – buttons to
adjust the Test Run Time (adjustable from 1 to 10 minutes) per
station; then press Run.
1 2
C
A conrmation screen appears.
D
Once Run is pressed, stations can be monitored and advanced by
turning the dial to the AUTO position and using the Adv button.
Press the + and – buttons to increase or decrease Run Time
minutes for the current station.
3 4
To Next Page
Loading...
Need help?
General
