58
HSB Series Chartplotter
3. If you NAME a route, use the trackpad to move the cursor right or left
to the character you wish to edit. Then use the top or bottom of the
trackpad to increase or decrease the letter or number.
4. Press ENTER to clear the Name List, then to return to the default soft
key display, press ENTER again.
Editing a Route
Once you have created a route, you can edit it by:
• Inserting a Waypoint into the route
• Adding waypoints at the end of the route
• Removing a Waypoint
• Reversing a Route
• Moving a Waypoint as described in Section 3.2
Any changes you make to the route affect only the current route. The
current route is always held in position 0 in the database, so you need to
Save the route if you want to keep the changes.
Inserting a Waypoint into a Route
You can use the context-sensitive cursor to insert one or more
waypoints in the current route. However, if the route is being followed
you cannot insert a waypoint into the current leg.
➤ To insert a new waypoint in the current route:
1. Move the cursor over the route leg into which you wish to insert a
waypoint, until the letters RTE and the route leg data box are
displayed. The Route soft keys are displayed.
2. Press ENTER. The cursor changes to a four-way arrow, controlling a
new waypoint. The waypoint is connected to the existing waypoints
on either side with a dashed line.
3. Move the new waypoint to the required position, and press ENTER
to drop it and return to normal cursor operation, or CLEAR to
abandon the operation.
The new waypoint is temporarily added to the waypoint list and named
with the first available waypoint number. The waypoints in the current
route are re-numbered to identify the new positions.
Note: if you Clear the route before it is Saved, the new waypoint is
removed.
Editing a Route
NAME
ROUTE
To Next Page
Loading...
Need help?
General