Category Item Setting
Security User
Lockout Policy
Lockout Active
For details, see page 45 "User Lockout Function".
Security User
Lockout Policy
Number of Attempts before
Lockout
5 times or less.
For details, see page 45 "User Lockout Function".
Security User
Lockout Policy
Lockout Release Timer Set to [Active] or [Inactive].
When setting to [Active], set the Lockout release
timer to 60 minutes or more.
For details, see page 45 "User Lockout Function".
Security User
Lockout Policy
Lock Out User for When setting "Lockout Release Timer" to [Active],
set the Lockout release timer to 60 minutes or
more.
For details, see page 45 "User Lockout Function".
Network
SNMPv3
SNMPv3 Function Inactive
To use SNMPv3 functions, set "SNMPv3
Function" to [Active], and set "Permit SNMPv3
Communication" to [Encryption Only]. Because
SNMPv3 enforces authentication for each
packet, Login log will be disabled as long as
SNMPv3 is active.
Security
Network Security
FTP Inactive
Before specifying this setting, set "Network
Security Level" to [Level 2] on the control panel.
Settings You Can Configure When IPsec Is Available/Unavailable
All communication to and from machines on which IPsec is enabled is encrypted.
If your network supports IPsec, we recommend you enable it.
Settings you can configure when IPsec is available
If IPsec is available, configure the settings shown in the following table to enhance the security of the
data traveling on your network.
6. Managing the Machine
172
To Next Page
Loading...
Need help?
General
