Overwrite icon
When Auto Erase Memory is enabled, the Data Overwrite icon will be indicated in the bottom right
hand corner of the panel display of your machine.
Icon Icon name Explanation
Dirty This icon is lit when there is temporary data to be overwritten, and
flashes during overwriting.
Clear This icon is lit when there is no temporary data to be overwritten.
• If the Data Overwrite icon is not displayed, first check if Auto Erase Memory has been set to [Off].
If the icon is not displayed even though Auto Erase Memory is [On], contact your service
representative.
• If the machine enters Low Power mode when overwriting is in progress, press the [Energy Saver]
key to revive the display in order to check the icon.
• If the Data Overwrite icon continues to be "Dirty" when there is no data to be overwritten, turn off
the machine's main power. Turn it on again and see if the icon changes to "Clear". If it does not,
contact your sales or service representative.
Erase All Memory
Overwrite and erase all data stored on the hard disk when you relocate or dispose of the machine. The
device settings stored on the machine's memory are initialized.
For details about using the machine after executing Erase All Memory, contact your sales representative.
4. Preventing Leakage of Information from Machines
66
To Next Page
Loading...
Need help?
General
