Engineering manual - SAB 193-233-283 S A-frame (including ATEX)
136/175
008831 en 2022.02
Settings
9. Settings
9.1 Control system
Compressors are delivered with the UniSAB III reading, safety and capacity regulating system
only.
Note: Changes in factory settings must only be carried out by an authorised refrigeration
company.
The control system is described in the UniSAB III Operating manual.
A UniSAB III Engineering manual is also available. This manual describes the control system
in more detail.
Therefore, set point settings, for instance, are not described in this chapter.
To Next Page
Loading...
Need help?
General
