ECO MULTI SYSTEM Unit Specifications
SM830063
I-15
1
1. Outdoor Unit
1-3. Control specifications
SPW – CR363GVH8 / SPW – CR363GV8
SPW – CR483GVH8 / SPW – CR483GV8
MODEL No. Outdoor Unit
SPW – CR703GVH8 / SPW – CR703GV8
SPW – CR903GVH8 / SPW – CR903GV8
Available
Cooling 18 – 30 °C
Thermostat
Setting temp.
Dry 18 – 30 °C
Heating 16 – 26 °C
Operation mode HEAT* • DRY • COOL • FAN
Mode setting
Fan speed Auto • Hi • Med • Lo
Timer ON • OFF • (Max. 72 hour)
Auto. flap Fan Aim / Sweep
Serial communication E1 – E 7
Improper address setting & others E8 – E18
Alarm message Activation of protective device P1 – P17
Thermistor failure F1 – F11
Fault with comp. & its circuit H1 – H13 , F27 , F28
Compressor contactor (Mg SW) abnormal H9 & H19
*
Cold draft prevention
Timer –
Indoor unit coil temp. E2 < 27 °C
Defrosting control* Reverse cycle, microprocessor control
Service function
Sensor temp. recall function
Past service warnings recall function (Max. 4 alarms)
System control
Multiple remote control Max. 2 controllers (Main : 1, Sub: 1)
Group control Simultaneous operation Max. 8 units
Automatic restart after power interruption
Test run function (built in 60 min. timer)
*: Only for heat pump type.
To Next Page
Loading...
Need help?
General
