5-47
SCANNER/INTERNET FAXâ–ºTRANSMITTING AN IMAGE
IMAGE SETTINGS
AUTOMATICALLY SCANNING BOTH SIDES OF AN
ORIGINAL (2-SIDED ORIGINAL)
The automatic document feeder is used to automatically scan both sides of an original.
The settings on 2-sided scanning are cleared when transmission has completed.
• You cannot use 2-Sided scanning when the original size is set to Long Size.
•
On the MX-B355W, duplex scanning is not possible when originals of mixed width are scanned.
1
After tapping the [Original] key, tap the
[Book] or [Tablet] key.
See the figure on the left to check the binding edge of the
original and select the key to be tapped.
In normal mode, tap the [2-Sided Tablet] or [2-Sided Book] key.
2
Tap the [Image Orientation] key with
the same orientation as the placed
original.
If this setting is not correct, a suitable image may not be
transmitted.
After the settings are completed, tap .
To cancel 2-sided scanning:
Tap the [1-Sided] key.
In normal mode, tap the [2-Sided Tablet] key or the [2-Sided Book] key that has been forcibly displayed and cancel the
display.
2-Sided
Original
Scan transmission
Front and reverse sides are scanned
A
C
G
AB
EF
J
L
KL
E
CA
Preview Auto Set
B/W
Start
Colour
Start
Original
Image
Orientation
Duplex Setup
1-Sided Book Tablet
8½x11
To Next Page
Loading...
Need help?
General
