Configuration (WBM)
5.13 Monitoring
LOGO! CMR2020, LOGO! CMR2040
120 Operating Instructions, 10/2016, C79000-G8976-C356-03
You assign an action to an event you have configured.
In the upper part of the page, you will see a list with the assignments configured up to now:
● A maximum of 32 assignments are possible.
If you have not yet specified an assignment, the list is empty.
In the lower part of the page, under "Change assignment", you will find the area required for
specifying an assignment.
Note
The monitoring of the event only becomes active with the assignment event → action
1.
You have configured message texts, signals, events and actions.
Assign the event to an action.
Select the "Activate assignment" check box.
With this, you activate the assignment for monitoring.
With the assignment of an action to an event, the relevant event is only monitored when
this assignment is active.
Note
Actions from events of LOGO! BM
The following requirem
ents apply to the monitoring of events from BM and configuring them
The connection between the CMR and BM is estabished.
The program status of LOGO! BM is 1 (RUN)
1. In the lower part of the page, click the "Add" button.
2. Following this, you will see three blocks with input boxes, drop-down lists, check boxes
and grayed out text boxes for the configuration.
Name
● Freely selectable symbolic name for this assignment.
● Activate/deactivate the assignment in the "Activate assignment" check box.
To Next Page
Loading...
Need help?
General