Additional information on SMS
B.2 SMS error messages
LOGO! CMR2020, LOGO! CMR2040
Operating Instructions, 10/2016, C79000-G8976-C356-03
165
If, for example, a PI-SMS message requested using SMS was sent incompletely, repeat your
request SMS message.
You will find a list of all possible error messages in SMS error messages (Page 165).
The SMS command was executed successfully.
Invalid Command SMS keyword could not be recognized.
Check the uppercase/lower case characters and syntax.
Transfer parameter not correct; password not correct.
No Success Values could not be set or read.
Try Again The CMR is currently being reconfigured. The request can-
No connection to LOGO! BM
• LOGO! BM not activated or wrong IP address set.
• Cable between LOGO! BM and LOGO! CMR discon-
nected
No GPS Signal
• GPS not configured
• GPS signal cannot be received because there is no line
of sight to the GPS satellite.
Not supported by LOGO! BM The setting of bits in the VM of the LOGO! BM is not sup-
ported by this device version (previous firmware version)
Syntax of all SMS commands
Syntax of the SMS commands and possible responses
What information would I like to have?
Read diagnostics data from the CMR
Read GPS position from the CMR
To Next Page
Loading...
Need help?
General